eth0

Open up the file/etc/defaults/dhcp3-server and add the required interface to the INTERFACES = "" line. e.g for eth0, the line will look like INTERFACES = "eth0″.

MakeUseOf.com 2010

Open up the file/etc/defaults/dhcp3-server and add the required interface to the INTERFACES = "" line. e.g for eth0, the line will look like INTERFACES = "eth0″.

MakeUseOf.com Varun Kashyap 2010

In my case it was "eth0" - but this is not always the name it will get.

Site Home Virtual PC Guy 2010

Therefore the network interface used in troubleshooting mode is called eth0 - just like any other regular Linux box.

Netvouz - new bookmarks jecogite 2010

When you are working in the service console while the VMkernel is loaded, the service console's network interface is not called eth0, but is called vswif0 instead.

Netvouz - new bookmarks jecogite 2010

Modprobe. conf has the line "alias eth0 e1000e" which is the module for the network card in the original machine.

LinuxQuestions.org mrholepunch 2010

This: alias eth0 8139too should read alias eth0 ipw2200

PCLinuxOS-Forums 2009

In networkscripts / wirelessd, my eth0 was my problem card (edited the file to read "eth2") then renamed the file for eth2.

PCLinuxOS-Forums 2009

In networkscripts / wirelessd, my eth0 was my problem card (edited the file to read "eth2") then renamed the file for eth2.

PCLinuxOS-Forums 2009

As "root" edit the / etc / modprobe. conf file to add alias eth0 3c59x, eth2 zd1211rw.

PCLinuxOS-Forums 2009