steam-pipe

The fats are melted in a copper, by means of a steam-jacket, or coil of steam-pipe in the copper, and the soda-lye is run in until complete union has taken place.

Scientific American Supplement, No. 447, July 26, 1884

It is easy to rotate the centrifugal machine by a belt from the mill, but better by a small engine attached, the power for which can be conducted by a small steam-pipe, and the distillation of the bisulphide can also be conducted without danger by the use of steam, as its boiling point is a very low one.

Scientific American Supplement, No. 447, July 26, 1884

A two-inch steam-pipe there was covered with this material.

The American Architect and Building News, Vol. 27, No. 733, January 11, 1890

The diameter of the steam-pipe is from ¼ to ½ inch according to the size of the bell, and the distance of the clapper from the bell is a little less than the diameter of the corresponding cock.

Scientific American Supplement, No. 458, October 11, 1884

Vicksburg, she was damaged in the hull and had a steam-pipe cut away, but this was soon repaired.

Memoirs of the Union's Three Great Civil War Generals

The most correct data available show that the radiation from uncovered two-inch steam-pipe, with 60 pounds steam-pressure, is 391.83 kilo. centigrade heat-units one foot one hour, or 21,739.78 kilos. of coal for 100 feet per year of 300 days of 10 hours each; one kilo. equals 2,205 pounds.

The American Architect and Building News, Vol. 27, No. 733, January 11, 1890

Indeed, the exact nature of the lagging matters comparatively little, because the active substance in retaining the heat in the acetylene generator or the steam-pipe is the air entangled in the pores of the lagging; and therefore the value of any particular material depends mainly on its exhibiting a high degree of porosity.

Acetylene, the Principles of Its Generation and Use

Isaac dully remembered the huge coils of steam-pipe that curled up the side of the wall.

McClure's Magazine, Vol. 6, No. 2, January, 1896

A row of lighted gas-jets placed near the point where the sheet goes on to the "flyboard," a heated steam-pipe, and many other things have been used, but a new device by which electricity is generated and carried into the press, and there neutralizes the electricity in the paper, is the best of them all.

The Building of a Book A Series of Practical Articles Written by Experts in the Various Departments of Book Making and Distributing

The steam-pipe is made with a bend as usual, to allow for contraction and expansion.

Scientific American Supplement, No. 458, October 11, 1884